Home > TOGGLE CLAMPS > Push-Pull type toggle clamps > No. 6860 Combination clamp, red handle


Combination clamp with red handle

Galvanized and passivated. Rivets made of stainless steel which run in hardened bushings. Bearings are pre-lubricated.
Ergonomic, oil-resistant handle with large grip surface and soft components.

Order
no.
Size F1
[kN]
F2
[kN]
Weight
[g]
93831 1 1.0 1.0 340
93880 2 2.0 2.0 700
93864 3 3.0 3.0 1620

Application:
Precise positioning and reliable clamping of individual components are of paramount importance when welding fixtures. In practice, this is guaranteed through the simultaneous use of rods and vertical toggle clamps, or by one's own complex design. The AMF Combiclamp accomplishes these two tasks in one operation, eliminating the need to use different toggle clamps. The sliding block guide on the Combiclamp converts the motion of the lever arm into a horizontal and vertical clamping movement, through which the workpiece is positioned and clamped at the same time. See for yourself the saving potential of using the new AMF Combiclamp!

Advantage:
- Positioning and clamping in one operation
- Robust and stable design
- Workpiece easy to remove thanks to the fully retracted clamping arm
- Optimized quality consistent with the AMF quality standard.

Dimensions:
Order
no.
Size A B C D E F G H H1 H2 HW1 min. HW1 max. HW2 min. HW2 max. I K L M N P
93831 1 17.0 33 40 5.5 15 0.5 22 36.0 74 62 25 32 5 10 12 7.5 150 34.5-39.5 53 55
93880 2 19.5 56 50 6.5 32 9.0 28 46.0 94 87 30 40 14 24 16 12.5 219 48.5-61.5 75 75
93864 3 29.0 74 50 8.5 37 14.0 34 55.5 110 106 40 50 20 30 20 20.0 270 60.0-80.0 96 90