Home > STANDARD CLAMPING ELEMENTS > Setting Elements > No. 6419 Floating clamp
Order
no.
Size Slot G Md min. - max.
[Nm]
F
[kN]
Setting travel H Clamping stroke H2* Weight
[g]
75754 12 14 M12 15-30 2-8 102-112 0-12 1880
75622 16 18 M16 50-115 8-25 163-175 10-25 6250

* Clamping stroke = clamping range with upper and lower standard clamping jaw

Application:
1. Fasten floating clamp on fixture or machine table.
2. Adjust height stop and swivel range with red adjustment sleeve and lock with threaded stud. When setting the upwards height limitation, allow for generous play (workpiece manufacturing tolerance).
3. Press floating clamp downwards.
4. Swivel clamping jaws in as far as they will go. - The floating clamp is positioned with light spring force on bottom of workpiece.
5. Tighten floating clamp with hexagon nut. - During the clamping process the workpiece is clamped and at the same time supported.
6. Unclasping is carried out in the reverse sequence.

Note:
- The floating clamp is used to clamp and support over determined clamping points on components.
- For customer-specific clamping situations the supplied clamping jaws can be replaced with the following clamping jaws (Nos. 6419B-12 and 6418B-16) (max. tightening torque = 43 Nm) Advantage:
- Especially suitable for large, hard-to-machine components (size 16).
- No deformation when clamping weak components.
- Vibration suppression during machining.
- Clamping of ribs, creases and tabs for stiffening on clamped components.
- Deformation-free clamping of blanks.


Dimensions:
Order
no.
Size SW1 SW2 B B1 D H1 H3 H4 H5 L L1
75754 12 46 18 28 15 57 163 26.8 21 32 39 46
75622 16 55 24 54 20 80 261 40.0 29 45 54 68